EasyDose Quick Start Guide
Power button
Click once to turn on, press and hold momentarily to turn off.
Prime button
Push this button and pull the trigger to fill the barrel. Point the Gun up to expel any air in the barrel. This gives manual control of the piston. Press P button again for mPrime (Micro prime). This is a slower speed allowing fine control. Click again to exit this mode.
Menu button
Use this button to adjust the delivery and refill speed. Also, use it to turn on sound alert, repeat dose delay, multi-dose (max 10ml dose) and barrel change. The Menu button also functions as the Select button.
Statistics button
Push to see the amount of product administered and the number of doses
Up and Down buttons
Push these buttons to adjust the dose volume.
Dose Mode
You can use the arrow keys to adjust the dose by volume or weight. If you select Weight then input the dose units and dose rate.
Piston Speed
A further press of the Menu button allows you to adjust the delivery and refill speed. Use the arrow keys to change the speed up or down to suit.
Sound Alert
This setting turns on or off the sound alert at the end of each dose.
Dose Delay
This setting prevents double dosing if you accidentally pull the trigger twice. Set to 1s, 2s, or 3s for a forced delay between doses.
Multi Dose
If you turn this feature ON any dose will be limited to a max of 10ml. A dose larger than 10ml will be automatically be split into equal doses.
Barrel change
Use the Arrow key to select the TICK and follow the prompts to change the barrel and piston.
Take note of the polarity of the batteries. Remove the 2 batteries from the bottom of the Dosing Gun and insert them into the charger.
It is imperative that you clean the barrel after every session. Remove the barrel, rinse the barrel with clean, warm water and dry it thoroughly. Remove the inlet and exit valves and clean thoroughly. Lubricate the piston O-ring with petroleum jelly or food/cooking oil.